Foam Boards can be purchased at most office supply stores, Wal-Mart or Kinko’s in either Plain or with self adhesive back in either white or black. Buy a board bigger than your print.

Tools & Supplies needed

1. Straight Edge

2. Exacto blade/ Box cutter

3. Spray mount adhesive (3M super 77 works best)

4. Foam double sided mounting tape to mount your print on wall

Quick-Stick Self Adhesive Foam Board

1. With a straight edge trim two sides of your print upto the image.

2. Peel back protective release paper about 1" from across the top of the mounting board.

3. Align edge of print with mounting board.

4.Slowly peel back the rest of the release paper while firmly pressing down, smoothing the entire surface to avoid trapping any air bubbles.

5. Trim edges of print if necessary.

Plain Foam Board

1. With a straight edge trim two sides of your print up to the image

2. Use the 3M Spray adhesive (or comparable spray) to Spray your board evenly specially the edges.

4. Align corner edge of print with the board ( lot easier with two people)

while firmly pressing down, smoothing the entire surface to avoid trapping any air bubbles.

5. Trim edges of print with a sharp exacto knife or box cutter.

6. Use double side foam tape to mount on your wall.

And if you want to avoid this most frame shops or Kinko's can mount your image onto foam boards for you.